CARL Paper Cutter, Disc Cutter DC-200N, 10 Sheets Capacity, A4 Compatible

CARL Carl Office Supplies Paper Cutter A4 Compatible 10 Sheets Cut DC-200N

Used for creating copied booklets.
Has cut around 100 sheets of copy paper.

The cutter blade is clean with no rust.
Only copy paper has been cut, so there is no glue or other residue.
The cutting mat was only used on the left side of one surface.

The instruction manual has some stains.
The outer box lid is partially torn, so it has been reinforced with tape. It also has some dirt.

I confirmed the operation before listing, just in case.
5 sheets of copy paper were cut in 1 slide (top to bottom).
10 sheets were cut in 3 slides (top to bottom, bottom to top, and quickly top to bottom).

Shipping will be done via 80-size Takkyubin, with the outer box wrapped in cushioning material and placed in a shipping vinyl bag.

[Cutting Mat]
The cutting mat can be used in 4 locations (left/right, front/back), making it economical. (2 locations per side x 2 sides)
[Cutting Capacity]
Rotary blade: Approx. 10 sheets (0.9mm thick, 64g/m2 copy paper) is the guideline for 1 pass.
Perforating blade: Approx. 3 sheets (64g/m2 copy paper).
*When using the perforating blade, cutting back and forth will cut through the paper.
[Materials that can be cut]
Cardboard (up to 1mm thick), soft vinyl (up to 0.8mm thick), hard vinyl (up to 0.4mm thick), PP film (up to 0.4mm thick).
*When cutting soft materials other than paper, place PPC paper or similar underneath.
[Included with main unit]
DCC-28/Rotary blade x 1, DCM-310/Cutting mat x 1.

Self-publishing
Slide-type paper cutter